If you smell gas do not proceed with lighting the pilot on your water heate. This starts the flow of gas to the pilot burner.

71 Reference Of Pilot Light Electric Heater Water Heater Hot Water Heater Repair Gas Water Heater

When the flame ignites continue to hold the gas knob or button down for a full minute.

How to light a pilot light on a water heater. Hold the button down for up to a minute to ensure that the light stays lit. Some water heaters have a separate button for pilot mode usually a red one which youll press and hold. Smith Water Heater Take the access panel off the side of the AO.

If you have a new style water tank with a built-in ignition switch press this button. Continue to hold down the red button for one minute after the pilot is lit and then release it. If your water heater is old-style push down on the regulator valve and then apply your match or lighter to the tip of the pilots valve.

While continuing to press down on the red button press the piezo ignitor striker repeatedly until the pilot light is relit. While still holding the gas down light that pilot. While still holding the gas down light that pilot.

While still holding the gas down light that pilot. When relit the water heater pilot light flame should wrap around the thermocouple bulb. Turn the gas control knob on the side of the water heater to the Off position and allow the room to air out for approximately 10 minutes.

While holding down the pilot gas valve or the red button with one hand you will use your other hand to quickly light the pilot. Hold the red button down while pressing the piezo ignitor striker found to the immediate right of the gas knob repeatedly until the pilot is lit. Then release it slowly and make sure the light is still lit.

This will start the flow of gas so you can light the flame. You can see the pilot light through the viewing window on the water-heaters inner door. If the water heater has a manual ignite button press that to light the pilot.

Use a flashlight or a headlamp to find the burner inside. Open the doorcover over the pilot light access. Click here httpsgoogliSGf5jSome old water heaters will need to be lit with a match.

Light the pilot burner. You can see the pilot light through the viewing window on the Rheem water heaters inner door. Turn the control valve to on.

Illuminate the pilot burner with the flashlight. Press down on the ignitor button while holding the red set button until you see the pilot light come on. If You Have a Gas Water Heater It Is Important to Know Your Pilot Light If you woke up to a cold shower theres a good chance the pilot light on your water heater has gone out.

Do not release the regulator valve for a minute or so. Turn the gas regulator valves knob to Pilot press down on it and hold it down. Likewise is it dangerous if the pilot light goes out on water heater.

How to Light the Pilot Light in an AO. You may have to press the ignitor button a couple times until the pilot is lit. You should hear a clicking noise until the pilot burner lights.

Turn the gas knob to Pilot press and hold it down. Turn the gas knob to Pilot press and hold it down. Step by step instructions for relighting a gas water heater pilot light.

When the gas burner comes on use a 5050 dish soapwater mix to test the screw joints for air bubbles that indicate leaks. Continue to hold down the red button for one minute after the pilot light is lit and then release it. Set the gas control knob to the Pilot position.

If it doesnt have the button or the button fails press the regulator valve and hold a grill lighter or long match to the pilot light valve until the pilot ignites. Relight the pilot light. How to Light a Water Heater Pilot Light.

Learn how to turn it back on and youll be known around your house as the keeper of the flame. Some water heaters have a red or black igniting button and others need to be lit manually with a long lighter. You can get replacement parts on amazon if you need them.

When the flame ignites continue to hold the gas knob or button down for a full minute.